2004 Porsche 911 GT3FACTORY OEM SERVICE PROCEDURE

Service Precautions

The following precautionary measures must be taken before disconnecting or total discharge of the battery or serious electrical damage can occur:

  1. Never disconnect battery with engine running.
  2. Ensure battery is securely connected before starting.
  3. Do not use a boost charger to start engine.
  4. When jump starting use jumper cables with overvoltage protection.
  5. Always disconnect the battery before performing any welding.
  6. Always ensure ignition is in the OFF position before disconnecting any electrical components. Except for the following: On vehicles equipped with alarm siren tilt sensor M536 (located next to battery) ignition must be in the ON position with all loads turned off before disconnecting battery to ensure alarm siren will not be triggered.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.