Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Limp-home mode 2
Fault caused by incorrect gear ratio or unusual shifting!Β
Explanation of table headings and content:
- Shift state before setting fault: States the selected position of the selector lever and the selected gear before the fault occurs and is set.
- Step 1: Vehicle in motion. After a fault occurs and is set, the Tiptronic control unit switches to limp-home mode. The gear engaged before the fault was set remains and the torque converter lockup clutch is not activated.
- Step 2: Motion interrupted, the vehicles is stationary, the gear engaged in 'step 1' is held. Shift solenoid valve C2 (modulation pressure) and shift solenoid valve B1 (modulation pressure) are 'ON'. All other shift solenoid valves are 'OFF'. Shift operation for 'gear 3' is prepared.
- Step 3: Shift operation for 'gear 3' terminates and the gear is held. Neutral-detect is started.
- Step 4: Shift operation for 'gear 5' is initiated. No 'neutral' state.
- Step 5 Shift operation for 'gear 5' terminates. No 'neutral' state and the shift solenoid valves are disabled.
| Limp-home mode 2 | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Shift state before fault set | Step 1 | Step 2 | Step 3 | Step 4 | Step 5 | ||||||
| Shift response | Torque limit [Nm] | Shift response | Torque limit [Nm] | Shift response | Torque limit [Nm] | Shift response | Torque limit [Nm] | Shift response | Torque limit [Nm] | ||
| R | R | state remains same | 100 | state remains same | 100 | state remains same | 100 | state remains same | 100 | Β | 100 |
| D | 1 | engage d gear held, no activation of torque converter lockup clutch |
150 | Shift solenoid valve C1/B1 'ON'; other shift solenoid valves 'OFF' engage d gear remains! |
150 | state remains held neutral detect |
150 | shifts to 'gear 5' | 150 | shift solenoid valves are disabled |
150 |
| D | 2 | ||||||||||
| D | 3 | ||||||||||
| D | 4 | ||||||||||
| D | 5 | ||||||||||
| D | 6 | ||||||||||
| 'R' control | enabled | enabled | enabled | enabled | disabled | ||||||
| Power switch (in Tiptronic control unit) | ON | ON | ON | ON | OFF | ||||||
Power switch (in Tiptronic control unit):Β
With the power switch (in Tiptronic control unit) 'ON', the Tiptronic control unit can control the transmission.
With the power switch (in Tiptronic control unit) 'OFF', the Tiptronic control unit cannot control the transmission.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
