2003 Porsche Cayenne TurboFACTORY OEM SERVICE PROCEDURE

Control unit function (coding/programming): Adaptation

NOTE: Undeleted adaptation values result in rough shift operations in the transmission. The Tiptronic control unit needs a certain amount of time to replace existing values with new values.

Work to be carried out after replacing a control unit:Β 

  • Delete the adaptation values using the Porsche System Tester II No. 9588
  • Teach the accelerator pedal

To teach the accelerator pedal:Β 

  • Ignition ON
  • Press the accelerator pedal for at least 3 seconds

The accelerator pedal can also be taught while the vehicle is in motion, provided the accelerator pedal is pressed for at least 3 seconds. No indication is given that the teaching procedure is complete.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.