Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Internal function test
When the ignition (terminal 15) is switched on, a control phase is run in order to check the activation/deactivation of the passenger's air-bag ignition circuit, including the airbag switch and the indicator light (passenger's airbag OFF display). This control phase is evident by the fact that the indicator light lights up for approx. four seconds (but not when the airbag switch is OFF, i.e. the passenger's airbag is deactivated). If implausible statuses are detected in the passenger's airbag ignition circuit, the indicator light starts flashing and the airbag warning light may also come on. If such a situation arises, read out the fault memory and work through the diagnosis/troubleshooting instructions.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
