2003 Porsche Cayenne TurboFACTORY OEM SERVICE PROCEDURE

Compressor OFF code

In menu item 'Inputs signals', the actual reason for compressor shutdown can be read out. Numbers from '1' to '23' are output. The meaning of each number is shown in the following table.

NOTE: If the compressor is switched on, the display shows the number '15' or the text 'comp. ON'!
AIR CONDITION COMPRESSOR REFERENCE CHART

1 Refrigerant pressure too high
  • above 32 bar compressor OFF
  • below 26 bar compressor ON again
2 Blower at step '0' (actual voltage < 3 V)
or blower/blower drive circuit faulty
3 Refrigerant pressure too low
  • If outside temperature above 5 °C:
  • below + 1.4 bar compressor OFF
  • above + 2.0 bar compressor ON again
  • If outside temperature below 5 °C:
  • below + 0.5 bar compressor OFF
  • above + 1.0 bar compressor ON again
5 Engine runs for < 5 seconds after starting
6 'ECON' mode active
7 Air-conditioning system 'OFF'
8 Outside temperature too low
  • below + 2 °C compressor OFF
  • above + 3.5 °C compressor ON again
10 Vehicle voltage too low (< 10.1 V when engine running)
11 Engine temperature > 118 °C
(does not apply for all versions)
12 Shutdown request from engine control module via CAN
13 Vehicle voltage too high (> 1 6 V)
14 Evaporator temperature too low
  • below -2 °C compressor OFF
  • above 0 °C compressor ON again
15 No condition for cutoff exists, the compressor is being activated.
16 Fault 'A/C compressor drive circuit'
17 Fault 'Pressure sensor'
18 Engine speed too high (> 3000 rpm when vehicle stationary (0 km /h )
19 Cutoff request from vehicle electrical system control module via CAN
20 Refrigerant loss
(does not apply for all versions)
23 Cutoff due to lack of radiator fan signal
(does not apply for all versions)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.