Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Porsche Boxster (986) F6-2.7LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
Engine Maintenance: Replacement of spark plugs
1. Jack up the vehicle at the take-up points provided.
2. Disconnect connection cable of the ignition coils.
3. Undo the two fastening screws (M6 x 25) of the plug coils and remove the 6 plug coils.
4. Unscrew the spark plugs using the spark-plug wrench.
5. Replace spark plugs. Tighten new spark plugs to 30 Nm (22 ftlb.), tighten remounted sparkplugs to 25 Nm (18.5 ftlb.).
6. Push on plug coils and tighten the fastening screws (M6 x 25) to 10 Nm (7.5 ftlb.). Subsequently push on the connecting cable of the plug coils.
7. Lower vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.