Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Porsche Boxster (986) F6-2.7LFACTORY OEM SERVICE PROCEDURE
DME Control Module, Removing and Installing
Removal
1. Put rear body-protection cover on the vehicle.
2. Press off expanding rivets of the luggage compartment lining with a removal tool.
3. Undo four hexagon nuts (wrench size 10 mm).
4. Take off control module. Open locking clip and pull the control module connector off.
Installation
1. Engage control module connector in the control module guide and press and lock the plug onto the terminal strip.
2. Fasten the control module.
Tightening torque 10 Nm (7.5 ft. lbs.)
3. Fit luggage compartment lining.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.