Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Porsche Boxster (986) F6-2.7LFACTORY OEM SERVICE PROCEDURE
PCM
PCM diagnosis
Component Arrangement
Function of individual components
1. Display and operator control unit
The display and operator control unit is the main part of the PCM system.
It is operated with a so-called dial. A function shown on the display can be selected by turning this dial and activated by pressing it.
2. Navigation unit
The navigation unit is located below the operator control unit. It contains a CD-ROM with special map data, which allow the navigation system to orient itself in the road network.
3. GPS antenna
Signals of the "Global Positioning System (GPS)" are received to determine the position of the vehicle.
The GPS antenna is located in the centre of the dashboard and in front of the sun sensor. The GPS antenna is covered by a cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.