Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Porsche Boxster S (986) F6-3.2LFACTORY OEM SERVICE PROCEDURE
Pinpoint Tests
Fault overview / troubleshooting (diagnosis / test plan)
1-15:
16-23:
Notes on fault memory / troubleshooting
The ABS MIL or TC MIL can light up although no fault is stored in the fault memory. The following faults are possible in this case:
- Mechanical switching contacts (arrows) in the control module connector bent. As a consequence, these contacts are permanently connected to ground (ground of PIN 19 connected to PIN 20 and PIN 21).
Explanation: Normally, these contacts are grounded only when the connector is pulled off. This causes the ABS MIL or the TC MIL to be activated when the engine is running.
- When the engine is running, the "terminal 61" signal is missing at the control module. This can be checked with the Porsche System Tester 2 via the Input signals menu).
Work after fault elimination
The fault memory must be erased after a fault occurs in the anti-lock brake system and is eliminated.
Then perform a short test drive and perform a TC control operation, taking the road conditions into consideration. Then read out the fault memory again.
Fill/bleed the system after the hydraulic unit has been replaced or removed and reinstalled. Then perform a system test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
