2000 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Install The TIPTRONIC Control Unit

  1. Connect the connector on the control unit and insert the closing bracket until it engages.
    Fig 1: Connecting Tiptronic Control Unit Connector On Control Unit
    G03102778Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Position control unit and secure with the fastening nuts. Tightening torque: 10 Nm (7.5 ft.lb).
    Fig 2: Installing Control Unit Screws
    G03102779Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Fold back the carpet lining into position and fasten with the clips.
  4. Program the Tiptronic control unit with the Porsche System Tester. See CODING THE TIPTRONIC CONTROL UNITΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.