Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Removing And Installing Selector Lever Cable: Installation
- Route the selector lever cable (1) through the rear wall to the correct position on the transmission and fasten on the transmission. See Fig 1
- Insert locking piece in the rear wall and fit rear wall cover.
- Fasten cable on support bracket (2). See Fig 2 .
- Fit cable holder.
- Move selector lever and transmission to position "P".
- Press cable into the open adjuster (1) and close the adjuster (3). The locking sleeve must move to the end position automatically.
- Check adjustment of the selector lever cable. See ADJUSTING SELECTOR LEVER CABLEΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
