2000 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Programming map as of 7.2

  1. Select "Control unit programming" with the cursor keys in the DME control module and press the >> key.
  2. Select "Program map" >> and observe the programming instructions.
  3. Enter old DME programming code, >>, confirm with F7 key.
  4. Specify transmission type, >>, code with F8 key.
  5. Select the required program map and confirm with the >> key. See VERSION (DATA RECORDS)Β  .
  6. The tester shows whether the data status is current or not current.
  7. Proceed further according to the tester instructions.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.