2000 Porsche Boxster Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removing Control Module For Parking Assistant

  1. Unscrew both fastening screws -arrow-Β  from the cover. See Fig 1 .
    Fig 1: Removing Control Module For Parking Assistant
    G03092749Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Turn the cover over and disconnect both electrical plugs.
    Fig 2: Disconnecting Both Electrical Plugs
    G03092750Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Unscrew the control module from the cover with the two fastening screws.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.