Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Porsche Boxster (986) F6-2.7LFACTORY OEM SERVICE PROCEDURE
Starting Switch Replacement
Removal
1. Disconnect battery ground cable.
2. Turn ignition key to position 0 and remove.
3. Remove air duct (A). The air duct is plugged in.
4. Pull connecting plug off ignition switch.
5. Remove screw locking paint in the threaded bores of the two fastening screws (short arrows). Slightly loosen both fastening screws (short arrows) using special tool 9631 (Figure 483-97) and pull the ignition switch out of the housing (motion arrow).
Installation
1. Move ignition switch to position 0 (same position as lock barrel).
2. Insert ignition switch into the housing. Tighten fastening screws using special tool 9263 and subsequently secure with screw locking paint.
3. Push plug onto ignition switch and fit air duct.
4. Connect battery ground cable. Perform function test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
