Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Porsche Boxster (986) F6-2.7LFACTORY OEM SERVICE PROCEDURE
Memory Positioning Systems: Service and Repair
General
The automatic lowering of the rearview mirror aids the driver during parking manoeuvres. The rearview mirror is lowered by the set value as soon as reverse gear is engaged. If reverse gear is disengaged again or the rearview mirror switch touched with reverse gear still engaged, the rearview mirror returns to its stored position.
Information:
This function is only available in vehicles with seat memory.
The following settings can be selected from the menu and encoded using the Porsche System Tester 2.
- Parking aid (active or not active)
- Parking aid with rearview mirror (right or left)
- Lowering
The system function can be activated or deactivated under menu item Parking aid.
Either the right-hand or left-hand rearview mirror is selected and activated under the menu item Parking aid with rearview mirror.
The degree to which the rearview mirror is lowered is set under the menu item Lowering.
Activating the parking aid
1. Connect the PST 2 with the ignition off, then switch the ignition on.
2. Switch on the PST 2 and wait for the start-up screen.
3. Press the [>>] key to go to the next level.
4. Select the vehicle type Boxster in the left-hand window using the [Up arrow] key.
5. With the [Up arrow] key, select the Seat memory control module and press the [>>] key to go to the next level.
6. With the [Up arrow] key, select Modify coding and press the [>>] key to go to the next level.
7. The Parking aid menu item is already high-lighted on your screen. Press the [>>] key to alter the coding.
8. Select the menu item active using the [Up arrow] key.
9. Press key F8 (coding).
The parking aid is now activated.
10. Press the [<<] key to switch between the right-hand or left-hand door mirror.
11. With the [Up arrow] key, select Parking aid with rearview mirror and press the [>>] key to alter the coding.
12. Select the desired side right or left using key [Up arrow] or [Down arrow].
13. Press key F8 (coding).
The selected rearview mirror is now activated.
14. Press the [<<] key to set the degree of lowering of the door mirror.
15. With the [Up arrow] key, select Lowering and press the [>>] key to alter the coding.
16. Select the desired degree of lowering using key [Up arrow] or [Down arrow].
17. Press key F8 (coding).
The selected degree of lowering has now been stored.
18. Press the [Esc] key 2x to quit this level.
Setting of the system is now complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
