1999 Porsche Boxster (986) F6-2.5LFACTORY OEM SERVICE PROCEDURE

DME Set Points





DME setpoints

Boundary conditions
- Ambient temperature approx. 20 °C
- Engine temperature 90 - 105 °C
- All loads switched off
- Engine idling

Nominal values


Factory service manual diagram




Factory service manual diagram




Factory service manual diagram





NOTE:
The stated values are the result of measurements of vehicles with different mileages and in perfect condition.

Different values can result from diagnosis in the workshop because of mileage and environmental influence. For DME diagnosis, it is important to look at several values simultaneously and in a collective group during troubleshooting.


Factory service manual diagram




Example:
An important collective group is formed by the values shown.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.