1997 Porsche Boxster AutomaticFACTORY OEM SERVICE PROCEDURE

Vacuum Diagrams: Introduction

NOTE: Information for year 2000 models is not available from manufacturer.

This article contains views or schematics of vacuum hose routing. Use these vacuum diagrams during visual inspection in BASIC DIAGNOSTIC PROCEDURES article. This will assist in identifying improperly routed vacuum hoses which may cause driveability and/or computer-indicated malfunctions.

NOTE: Emission equipment may be verified by underhood Emission Control Label. Always refer to Emission Control Label in engine compartment before attempting service. If manual and label differ, always use emission label specifications.
Chapter Navigation
Return to Chapter: Vacuum Diagrams
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.