Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Porsche Boxster AutomaticFACTORY OEM SERVICE PROCEDURE
DME 5.2.2 Diagnosis: Tools: General
NOTE:
In order to ensure that a fault is no longer present after a repair or after the fault memory has been erased, a short test should be performed. Only in this way can you ensure that all diagnostic routines have been performed by the DME control module.
In the case of Tiptronic vehicles, the Tiptronic fault memory must also be read out, because activation of the Check Engine MIL can also be initiated by the Tiptronic.
In the case of Tiptronic vehicles, the Tiptronic fault memory must also be read out, because activation of the Check Engine MIL can also be initiated by the Tiptronic.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.