1997 Porsche Boxster AutomaticFACTORY OEM SERVICE PROCEDURE

Software update

The software can be updated using the supplied CD-ROM drive.

  1. Connect CD-ROM drive with the Porsche System Tester 2
  2. Connect Porsche System Tester 2 and the CD-ROM drive to the mains power supply unit.
  3. Load CD-ROM in the drive and close the drive
  4. Switch on the Porsche System Tester 2.
  5. Select "Software installation" in the Configuration menu.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.