Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Porsche 911 Speedster, AutomaticFACTORY OEM SERVICE PROCEDURE
Using Malfunction Indicator Light (MIL)
- Turn ignition on. Ensure MIL comes on. Depress and hold accelerator pedal at Wide Open Throttle (WOT) for 3-5 seconds.
- After MIL goes out and comes on again, release accelerator pedal. This on-off period indicates self-diagnostic system is preparing to output diagnostic codes. See Figure .
- Next MIL on-off periods will represent first fault code stored. Record fault code, and again depress and hold accelerator pedal at WOT for 3-5 seconds. Release accelerator pedal, and record second fault code stored.
- Continue to depress and release accelerator pedal until Code 1000 is displayed, indicating end of output. See Figure .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
