1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Motor Relay (Pump Motor Runs)

With Light Emitting Diode (LED) on at position 4, depress button. If Lamp 3 (Green), test is satisfactory. Proceed to PROGRAM SWITCH POSITION 5. If Lamp 4 (Red) is on, repeat PROGRAM SWITCH POSITION 3.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.