1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Motor Relay (Neutral Position)

  1. If Lamp 3 (Green), test is okay. Go to PROGRAM SWITCH POSITION 4Β  . If Red light comes on, turn off ignition.
  2. Pull off control unit plug and check continuity in following circuits. Apply 12 volts to positive connector on control unit plug terminal No. 1 and ground on terminal No. 28. Test light on terminal No. 14 should come on. Test light must go out after pulling off terminal connectors No. 1 or 28. If not, go to step 3).
  3. Check motor relay for malfunction. Check tightness of ground terminals and positive connection on pump motor. Check continuity of pump motor. If pump motor is malfunctioning, replace hydraulic unit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.