1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Stoplight Switch

  1. Press on brake pedal. Digital display should be between 10-15 volts. A display of 0-.25 volts without operating pedal is normal. If readout is okay, go to PROGRAM SWITCH POSITION 23Β  .
  2. If there is no display, check stoplight switch including wires to switch and plugs, as well as wire from control unit plug terminal No. 25 to CEL plug S6. If display is less than 10 volts, eliminate contact resistance on both sides of plug and light connections or replace stoplight switch.
NOTE: The following tests require a Brake Test Bench (Chassis Dyno).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.