1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Speed Sensor Signal

  1. Place vehicle on braking test stand (chassis dyno), front and rear wheels respectively. Switch in brake rollers of test stand separately for front and rear wheels. Separate speed sensors are selected by depressing "VR", "VL", "HL" and "HR" buttons.
  2. Digital display should be 1.5. Check clearance. Use smallest value if display fluctuates. A digital display "999" means speed of test stand is too fast. If digital display between 0-1.5 is on, check the following and repair if necessary:
    • Speed sensors installed on incorrect wheel (check arrangement). Speed sensor must correspond to specified wheel and control unit inlet.
    • Clearance between speed sensor and gear ring excessive. Check for proper installation.
    • Check bearing play of front wheels.
    • Check speed sensor.
NOTE: Go to PROGRAM SWITCH POSITIONS 20, 21 & 22 only after performing PROGRAM SWITCH POSITION 23Β  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.