Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Diode In Flow Direction (ABS Indicator Lamp Not On)
- The ABS indicator should be on and digital display should read 1.5 volts. If test is okay, go to PROGRAM SWITCH POSITION 15Β . If not, go to step 2).
- If ABS indicator light is not on, check indicator light for burnout. Replace indicator light (if necessary). Go to step 3).
- Turn ignition off. Using an ohmmeter, check for continuity of diode between terminals No. 29 and 32 on disconnected control unit plug. Display must have high resistance once and then read low ohm resistance. Go to step 4).
- Pull off multiple pin plug on right side of instrument cluster. Check wires between terminals No. 29 and 32 for opens. Repair or replace wiring as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
