Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Left Front Speed Sensor (Insulating Resistance)
- Press "VL" button. Digital display should read 20,000 ohms. If readout is okay, go to RIGHT FRONT SPEED SENSOR (INSULATING RESISTANCE) test. If not, go to step 2).
- Check plug connection. Disconnect sensor plug. Bridge coupling plug (sleeve end). Repeat test. If digital display is okay, replace speed sensor. If not, go to step 3).
- Check wires from terminals No. 4 and 6 to coupling plug for malfunction. Inspect all wires for damage from rubbing. Repair or replace wiring as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
