1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Left Rear Speed Sensor (Internal Resistance)

  1. Press "HL" button. Digital display should read between 800-1800 ohms. If readout is okay, go to RIGHT REAR SPEED SENSOR (INTERNAL RESISTANCE) test. If not, go to step 2).
  2. Check internal resistance and continuity between terminals No. 8 and 9 of disconnected control unit plug. Check plug connection. If not okay, replace speed sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.