Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Solenoid Valve (Neutral Position)
Test is okay if Lamp 3 (Green) comes on. Go to PROGRAM SWITCH POSITION 2. If Lamp 4 (Red) indicator light comes on, check following:
- Ground connection has excessive contact resistance or an open in wiring harness.
- Turn off ignition. Pull off control unit plug and check continuity in following wires: from ground to hydraulic unit terminal No. 8 and from terminal No. 8 to control unit plug terminal No. 32.
- Solenoid valve relay malfunctioning.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
