Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Connecting Tester
NOTE:
All test procedures will correspond with numbers on the Bosch ABS Tester.
- Turn off ignition and pull off multiple pin plug (35-pin) on electronic control unit. Control unit remains installed. Connect multiple pin plug of electronic control unit with plug of tester.
- Connect tester to electronic control unit. Turn ignition on. Ensure all other electric equipment is off. NEVER operate vehicle with tester connected.
- Always perform all tests beginning with PROGRAM SWITCH POSITION 1. PROGRAM SWITCH POSITIONS 23 and 24 must be performed prior to PROGRAM SWITCH POSITIONS 20, 21 and 22.
- A brake test stand (chassis dyno) is required for PROGRAM SWITCH POSITIONS 20 through 23. Brake test stand rollers and vehicle tires must be dry during test. Selector lever of vehicle equipped with automatic transmission must not be in "P" position while testing rear axle.
- Never use a brake pedal winch to adjust braking force. Wait at least 20 seconds before repeating tests or changing channels.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
