Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Adapter Lead
An Adapter Lead (1684 460 120) is required to connect and test electronic relay with overvoltage protection in socket on back of tester. The overvoltage protection relay supplied with Bosch Tester (016.00) MUST NOT be used.
NOTE:
It is important that adapter lead for testing electronic relay of 928S vehicles is connected correctly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
