Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 944 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Abs Repair Precautions: Notes
Observe following precautions when performing repair operations outside of the ABS unit:
- Pull off plug on electronic control unit when welding with an arc welder.
- NEVER subject the electronic control unit to temperatures above 180Β°F (82Β°C) when painting a vehicle.
- Disconnect battery before charging with a fast charger. If battery has been removed, make sure wire terminals are tight on both connections after installation of battery. NEVER usea fast charger to start engine.
- NEVER disconnect or connect multiple pin plug on electronic control unit while ignition is on.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
