Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Porsche 928 AutomaticFACTORY OEM SERVICE PROCEDURE
Miscellaneous Components
MISCELLANEOUS COMPONENTS LOCATION
| Component | Location |
|---|---|
| ABS Hydraulic Unit | In engine compartment on left side. |
| Cooling Fan Resistor | On right front inner fender. |
| Cruise Control Servo | On left rear side of engine compartment. See Figure . |
| Diagnostic Connector | Top front side of engine. |
| Fuse/Relay Panel | Behind panel in passengers footwell. See Figure & Figure . |
| Ignition Coils (2) | Mounted on left and right wheel house walls. |
| TDC Transmitter | On top of clutch bell housing. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
