Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Porsche 928 AutomaticFACTORY OEM SERVICE PROCEDURE
Temperature Sensor I
- Connect ohmmeter to terminals 10 and 22 on EZF control unit plug. Readings should be as follows: At 32°F (0°C) equals 4.4 to 6.8 Ohms. At 60-85°F (15-30°C) equals 1.4 to 3.Ohms. At 105°F (40°C) equals 1 to 1.3 Ohms.
- For protective circuit, temperature sensor break (open circuit) equals ignition timing of -3°. Temperature sensor short circuit (grounded) equals ignition timing of -3°. Intake air temperature 122°F (50°C) equals ignition timing of -3°. These readings are with closed full throttle contact and 25 in Hg. vacuum.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.