Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Porsche 911 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Air Regulating Valve
- Screw in throttle by-pass screw completely when engine is running at steady idle speed. After brief deviation the idle speed must return to 800 RPM.
- Pull off electrical connector on air regulating valve. Connect center connection of valve with 12-volt supply. Connect an outer connection with ground. Valve must turn against stop. Exchange outer connections. Valve must turn to other stop.
- Connect a new air regulating valve on the wire plug to check activation of the valve from the control unit. The air regulating valve must vibrate noticeably (frequency activation) with engine running.
- If engine speed is boosted with the by-pass screw, the air regulating valve must move in closing direction. The air regulating valve must turn in opening direction when speed drops.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
