1985 Porsche 911 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor Control

  1. Oxygen sensor must be connected. Connect an analog dwell meter or voltmeter to the idle stabilizer test pins A and C. See Fig 1 .
  2. Start the engine. The display panel of test meter must jump between 0-100% dwell or 0-12 volts. If the display does not change in 6 seconds, check for problem in oxygen sensor circuits.
Fig 1: Porsche 911 Carrera Electrical & Vacuum Diagram
G42818
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.