1982 Porsche 924 Automatic TransFACTORY OEM SERVICE PROCEDURE

Engine Compression

Check compression with engine at normal operating temperature, fully open throttle, all spark plugs removed and at normal cranking speed. Crank engine at least 12 "Puffs" per cylinder.

COMPRESSION SPECIFICATIONS

Compression Ratio
  924 9.0:1
  924 Turbo 8.0:1
  944 9.5:1
Compression Pressure
  924
    Normal (New Engine) 114-156 psi (8-11 kg/cm2 )
    Minimum 85 psi (6 kg/cm2 )
    Maximum Variation 42 psi (3 kg/cm2 )
  All Other Models (1)
(1) Information not available from manufacturer.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.