1982 Porsche 911FACTORY OEM SERVICE PROCEDURE

Engine Compression

Perform compression test with wide open throttle and oil temperature not less than 140°F (60°C). Remove all spark plugs and allow about 12 piston strokes per cylinder test.

COMPRESSION SPECIFICATIONS

Compression Ratio 9.3:1
Compression Pressure
  Normal 142-184 psi (10-13 kg/cm2 )
  Minimum 107 psi (7.5 kg/cm2 )
Max. Variation
  Between Cylinders 22 psi (1.5 kg/cm2 )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.