Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2010G6 V6-3.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2010 Pontiac G6 V6-3.5L
Oil Pressure Sensor: Service and Repair
2010 Pontiac G6 V6-3.5LSECTION Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Disconnect the battery negative cable from the battery. Service and Repair
2. Remove the electrical connector from the engine oil pressure sensor.
Engine Oil Pressure Switch:
3. Remove the engine oil pressure switch.
Installation Procedure
Engine Oil Pressure Switch:
Caution: Refer to Fastener Caution Fastener Caution.
1. Install the engine oil pressure switch.
Tighten the switch to 16 Nm (12 lb ft).
2. Install the electrical connector to the engine oil pressure switch.
3. Connect the battery negative cable to the battery. Service and Repair
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.