Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Blower Motor Control Processor Replacement
2010 Pontiac G6 V6-3.5LSECTION Blower Motor Control Processor Replacement
Blower Motor Control Processor Replacement
Removal Procedure
1. Remove the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.
4. Remove the blower motor control processor.
Installation Procedure
1. Install the blower motor control processor.
Caution: Refer to Fastener Caution Fastener Caution.
2. Tighten the blower motor control processor screws.
Tighten the screws to 1.5 Nm (13 lb in).
3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.