2010 Pontiac G5 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Throttle Body
    GM1623767Courtesy of GENERAL MOTORS CORP.
  1. Install the throttle body.
  2. CAUTION: Refer to Fastener Caution .
  3. Install the throttle body bolts and tighten to 10 N.m (89 lb in).
  4. Fig 2: Identifying Engine Harness Electrical Connectors
    GM1647528Courtesy of GENERAL MOTORS CORP.
  5. Connect the TAC electrical connector (1).
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct ReplacementΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.