Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Pontiac Torrent FWD V6-3.4LFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal Position Sensor: Service and Repair
Accelerator Pedal Position Sensor Replacement
Removal Procedure
1. Remove the instrument panel left lower closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
2. Remove the connector position assurance (CPA) from the accelerator pedal position (APP) sensor connector.
3. Disconnect the APP sensor harness connector.
Note: Due to clearance issues, the upper attachment bolt cannot be removed from the accelerator pedal assembly. Loose the bolt completely and leave the bolt in the component until the assembly is removed from the vehicle.
4. Remove the APP assembly attachment bolts.
5. Remove the APP assembly from the vehicle.
Installation Procedure
1. Install the upper attachment bolt into the APP assembly.
2. Install the APP assembly into the vehicle.
Caution: Refer to Fastener Caution (Fastener Caution).
3. Install the remaining attachment bolts into the APP assembly.
Tighten the bolts to 25 Nm (18 lb ft).
4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
5. Install the CPA to the APP sensor harness connector.
6. Install the instrument panel left lower closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
