Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2009 Pontiac Torrent Base, AWDFACTORY OEM SERVICE PROCEDURE

Electronic Power Steering Motor Control Module Replacement

Fig 1: View Of Electronic Power Steering Motor Control Module

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure:
Remove the knee bolster. Refer to Knee Bolster Replacement .

Electronic Power Steering Motor Control Module Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 11.5 N.m (102 lb in)

Electronic Power Steering Motor Control Module

Procedure

Disconnect any electrical connectors as needed.
After repairs, perform the proper programming and calibration procedures. Refer to Power Steering Control Module Programming and Setup .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.