SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009SOLSTICE L4-2.0L TURBOREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGELECTRONIC BRAKE CONTROL MODULE PROGRAMMING AND SETUP
2009 Pontiac Solstice L4-2.0L Turbo

Electronic Brake Control Module Programming and Setup

2009 Pontiac Solstice L4-2.0L TurboSECTION Electronic Brake Control Module Programming and Setup



Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).

EBCM Reprogramming

If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS) (Programming and Relearning).

Setup for Component Replacement

The replacement of the electronic brake control module (EBCM), and the steering wheel position sensor (SWPS) or SWPS diagnostics procedures will require the scan tool steering position sensor calibration procedure for complete repair. Refer to Steering Angle Sensor Centering (Procedures)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.