2009 Pontiac Solstice L4-2.0L TurboFACTORY OEM SERVICE PROCEDURE

Connecting Rod, Engine

Connecting Rod Bolt
First Pass 25 Nm (18 lb ft)
Final Pass 100 degrees

Connecting Rod Bore Diameter - Bearing End 52.118-52.134 mm (2.0519-2.05252 in)
Connecting Rod Bore Diameter - Pin End 23.007-23.017 mm (0.9058-0.9062 in)
Connecting Rod Side Clearance 0.070-0.370 mm (0.0028-0.0146 in)
Connecting Rod Straightness - Bend - Maximum 0.021 mm (0.0083 in)
Connecting Rod Straightness - Twist - Maximum 0.04 mm (0.0157 in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.