Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009SOLSTICE L4-2.0L TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2009 Pontiac Solstice L4-2.0L Turbo
Oil Pressure Sensor: Service and Repair
2009 Pontiac Solstice L4-2.0L TurboSECTION Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (2) from the engine oil pressure sensor.
3. Remove the engine oil pressure sensor.
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the engine oil pressure sensor and tighten to 22 Nm (16 lb ft).
2. Connect the engine wiring harness electrical connector (2) to the engine oil pressure sensor.
3. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.