2009 Pontiac G8 BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to Adhesive Installation of Windshields .
    2. CAUTION: Refer to Fastener Caution .
  2. Install the windshield side reveal moldings screws.

    Tighten:  Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).

  3. Reposition the front door sealing weatherstrips to the pinch-weld flange.
  4. Install the push-pin retainers to the front door sealing weatherstrips located at the base of the windshield pillar.
  5. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Traverse) or Windshield Wiper Arm Replacement (Acadia) or Windshield Wiper Arm Replacement (Enclave) or Windshield Wiper Arm Replacement (OUTLOOK) .
  7. Install the rearview mirror. Refer to Inside Rearview Mirror Replacement .
  8. Install the rain sensor, if equipped.
  9. Close the hood.
  10. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.