Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac Wave (CANADA) L4-1.6LFACTORY OEM SERVICE PROCEDURE
Power Window Reinitialization
Power Window Reinitialization
Reinitialization Description
If the driver side power window regulator assembly has been replaced or reassembled, it must be reprogrammed once in the order for the safety function to operate properly. This can be done by operating the driver side window switch. If the reprogramming procedure is not performed, the driver side window will not close automatically.
Reinitialization Procedures
1. Press the driver side window switch until the window is under 100 mm (4.0 in) from the top of the window frame.
2. Pull the driver side window switch to the first step of the UP position and hold until the window is fully UP.
Important: Do not put the window switch to the second step of the UP position.
3. Continue holding the window switch for approximately 3 seconds after the window motor stall. The driver side window motor assembly is now programmed for the safety function.
4. Confirm the reprogramming procedure by performing the auto-up operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.