Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac Wave (CANADA) L4-1.6LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Service and Repair
Engine Control Module Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution).
1. Disconnect the negative battery cable.
2. Disconnect the engine control module (ECM) connectors.
3. Remove the ECM retaining nuts.
4. Remove the ECM from the ECM mount.
Installation Procedure
1. Position the ECM in place.
Notice: Refer to Fastener Notice (Fastener Notice).
2. Install the ECM to the ECM mount and install the retaining bolts.
Tighten the ECM retaining bolts to 4 N.m (35 lb in).
3. Connect the ECM connectors.
4. Connect the negative battery cable.
5. Perform the following procedures:
* Program the ECM
* Crankshaft Position System Variation Learn (Service and Repair)
* Idle Learn (Programming and Relearning)
6. Refer to Control Module References (Programming and Relearning) for programming and setup information.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.