Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac Wave (CANADA) L4-1.6LFACTORY OEM SERVICE PROCEDURE
Ignition Cable: Service and Repair
Spark Plug Wire Replacement
Removal Procedure
1. Turn OFF the ignition.
2. Remove the engine cover from the engine.
3. Disconnect the spark plug wire (1) at each spark plug.
* Twist each spark plug boot 1/2 turn before removing.
* Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.
4. Disconnect the spark plug wire from the coil (2).
* Twist each spark plug boot 1/2 turn before removing.
* Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the coil.
Installation Procedure
1. Install the spark plug wire on the coil (2).
2. Install the spark plug wire (1) at each spark plug.
Notice: If the boot to wire movement has occurred, the boot will give a false visual impression of being fully seated. Ensure that the boots have been properly assembled by pushing sideways on the installed boots. Failure to properly seat the terminal onto the spark plug will lead to wire core erosion and result in an engine misfire or crossfire condition, and possible internal damage to the engine.
3. Inspect the wires for proper installation:
* Push down on each boot in order to inspect the seating.
* Reinstall any loose boot.
* Wire routing must be kept intact during service and followed exactly when wires have been disconnected or when replacement of the wires is necessary. Failure to route the wires correctly can lead to radio interference and crossfire of the plugs, or shorting of the leads to the ground.
* Any time the spark plug wires or boots are installed on the spark plugs, new dielectric grease needs to be applied inside the boot.
Notice: Refer to Fastener Notice (Fastener Notice).
4. Install the engine cover on the engine.
Tighten the engine cover bolts to 3 N.m (31 lb in).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
