Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac Wave (CANADA) L4-1.6LFACTORY OEM SERVICE PROCEDURE
Alignment: Service and Repair
Front Toe Adjustment
1. Loosen the right and the left rod lock bolts.
Important: In this adjustment, the right and left tie rods must be equal in length.
2. Turn the right and the left tie rod adjusters to align the toe to 0 degrees ±10 minutes.
Notice: Refer to Fastener Notice (Fastener Notice).
3. Tighten the tie rod lock bolts.
Tighten the tie rod lock bolts to 64 N.m (47 lb ft).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.